![]() Once the status bar reaches 100%, the screen should show "rdy" and you should be good to go. Once you have your data downloaded, click "logtag" in the upper left corner of the VTMC software and select "quick reconfigure". If the data logger will not start, and shows either "stopped" or "not rdy" on the screen, the data logger will need to be downloaded and re-configured before you are able to restart it. The temperature will disappear and the word "stopped" will display. Simply hold the start/clear/stop button for 2 seconds and release. A second later the word ready disappears when the word ready disappears you must remove your thumb/ finger within 1-2 seconds or it will go back to the "ready" state. To start the VFC400: hold the start button down the word "starting" will display. The readings are paused until the next sample is taken and will show a temperature again when the probe is connected and the next sample is taken. This indicates the probe was disconnected when the logger took a sample. ![]() ![]() VFC 400-WiFi Installation and Setup InstructionsįAQS WHY ARE THERE DASHES WHERE THE TEMPERATURE SHOULD BE? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |